Introduction: Have you recently purchased a huffy cruiser cycle? Then congratulations, whether for leisure or commuting, this is the ideal equipment for you. However, before setting out on your first adventure, it will be necessary to assemble your new bike. This can be done quickly by following the steps below.
The following steps can be used to assemble any cruiser cycle. However, if you are still unsure about the process, it might be worthwhile to consult a professional or contact the supplier of your new bike.
Step 1: Remove the front wheel, seat and pedals from their packaging and attach the seat to the seat post securely. There will be screws that hold it in place and a clamp that must be loosened to allow for adjustment. Note that you will have to take care not to lose any of the small parts when removing the pedals.
Step 2: Attach one of the cranks to the pedal with a hex wrench and an adjustable or open-ended wrench. You will have to tighten it securely, but not so much that you damage the body of the crank arm itself. If you are unsure about this process, check your manual for guidance.
Step 3: Attach the cranks to the bicycle frame by turning them to parallel with the ground. Then, remove any stickers and tighten them in place by attaching a hex nut onto one of them and another onto both at once with two wrenches of the same size. Ensure that everything is tight before proceeding.
Step 4: Attach the front wheel to one of the forks, which should cover it. This is screwed into place with an Allen wrench and may require additional wrenches for removing.
Step 5: Remove any protective plastic from your pedals or other parts, making sure you do not lose any screws or other small parts. You can do this by striking them lightly with a ball-peen hammer, although such an implementation should only be used as a last resort.
Step 6: Attach the pedals to the cycle frame, using either another Allen wrench or an adjustable wrench and open-ended wrench to hold them in place firmly. Ensure that everything is tight before proceeding.
Step 7: Check all of your nuts and bolts to ensure that they are secure. If any parts need tightening, use a hex wrench, making sure not to over tighten them. Keep reading best cruiser motorcycles for women.
Step 8: Place the front wheel between the forks at the front of the bike frame with brake pads facing downwards. Ensure that it is pushed in before proceeding.
Step 9: Attach the handlebars to one side of the bicycle frame by performing the same process used for attaching the cranks, but use hex wrenches instead of an adjustable wrench for this part. Again, ensure that everything is tight before proceeding.
Step 10: Attach any accessories you have purchased with your cycles, such as a basket or child seat. You can also attach your water bottle holder at this time.
Step 11: Seat the front wheel in place by pushing it back until it comes into contact with the fork. Be careful not to pinch any brake cables before tightening the axle nuts securely using an adjustable wrench or two open-ended wrenches.
Step 12: Tighten any loose screws and bolts, ensuring that your cycle is secure and ready for use. Note that you may need to adjust the brakes once assembled to ensure they fit correctly over the tires before using the bike.
After following these steps and adjusting the brakes, you will be ready to use your new bicycle in safety. Remember that any manufacturer’s warranty may be void if a professional assemble your cycle for you.